Bosch SHI66A - Manual (Page 19)

E n g l i s h
18
DOOR PANEL INSTALLATION
SHU Models - Accessory Panel
Installation
If you have an SHU model and have
ordered an accessory panel kit, install
the panel prior to sliding the dish-
washer into place. The panel dimen-
sions are shown in Figure 15.
SHI Models - Panel Installation
SHI models come with additional
mounting hardware and a template
sheet with installation instructions. The
stainless steel models of the SHI
series also come with two extension
pieces. The extension pieces are used
to match the control panel height
(Figure 16, “B” dimension) to the
horizontal drawer line of the cabinets,
and must be installed as shown
in on
the template sheet. The standard piece
is used for drawer heights up to 6”
(152mm); the long piece is used for
drawer heights greater than 6”
(152mm) but 6-7/16” (164mm) or less.
If your drawers are taller than 6-7/16”,
you can either slide the extension piece
in as far as it will go, or remove it and fit
the door panel directly below the control
panel.
SHI/SHV Models - Panel Installation
SHV models come with additional
mounting hardware and a template
sheet that will show you how to mount
the panel. One side of the template
shows how to mount a one piece
panel; the other side shows how to
mount a two piece panel. Decide which
type of installation you want before
proceeding with the installation.
Figure 17/Ilus. 17
Figure 16/Ilus. 16
Figure 15/Ilus. 15
25”
(636 mm)
23-1/16”
(586 mm)
1/4” max.
(6 mm)
Door Panel Installation | Installation Panneau de Porte | Instalación - Panel de la Puerta
Fig. 17
Dimension
D (SHI)
E
(SHI & SHV)
F
(SHI & SHV)
20 11/16” - 25”
(526mm - 635mm)
27 3/16” - 30 5/16”
(690mm - 770mm)
23 3/16” - 23 3/8”
(589mm - 594mm)
Panel Dimension