Blaupunkt CR148 - Manual (Page 7)

l
DON’T connect the left and right speaker leads to each other or to the same speakers.
l
DON’T connect the front and rear speaker leads to each other or to the same speakers.
l
DON’T connect the negative speaker leads to each other.
l
DON’T connect the positive speaker leads to each other.
l
DON’T connect any active speakers (with built-in amplifiers) to the speaker leads unless their
owner’s manuals specifically state that this is O.K.
l
Cover the ends of any unused leads with electrical tape. This will prevent them from touching the
vehicle or each other and causing a short-circuit and damage to the radio or vehicle.
Connecting the Pre-Amp Outputs to External Amplifier(s)
To prevent short circuits or serious damage o the head unit, amplifier, and/or speakers:
l
Follow the amplifier’s instructions on how to connect the unit’s preamp outputs to the amplifier(s)
and connect the speaker(s) directly to the amplifier.
PORTABLE
FUSE (1 OA)
RIGHT FRONT
SPEAKER
LEFT REAR
SPEAKER
RIGHT REAR
SPEAKER
Harness has single blue lead that can
be used for either antenna motor or
amp trigger or spliced for use with
both. (See note 3.)