Blaupunkt CR148 - Manual (Page 14)

Bass, Treble, Balance and Fade
Press Mute/AUDIO for more than
second to access Bass. Subsequent presses access Treble,
Balance and Fade modes.
Bass -Adjust from to -7 at 2 using + to increase bass, to decrease.
Treble Adjust from to -7 at 2 using + to increase treble,- to decrease.
Balance Adjust balance from 9 (all the way left) using + to -9 (all the way right) using
Fader Adjust fader from 9 (sound only from the front) using + to -9 (sound only from the rear) using
Loudness (LD)
Press LD to increase sound of low and high frequencies. LOUD icon appears. To cancel, press LD
again.
Radio Operation
Last Station Memory
Each FM bank and AM band has its own last station memory which holds last-tuned frequency for
that band or bank irrespective of whether that frequency is stored into a preset.
Selecting Bands
Press SRC as needed to access FM2, AM/AMT banks.
Seek Tuning
Press A or V to seek next receivable frequency. Tuning stops at frequency that fulfills sensitivity
requirements predetermined by sensitivity set through
button.
Tuning Sensitivity (SENS)
Press for more that 2 seconds to switch between local (lo) and distant search sensitivity.
Radio Reception Hints
l
When listening to weak or distant AM stations, adjusting the Treble to minimum (-7) will reduce
noise and improve sound.
l
In general, set SENS to DX if in rural areas or where stations tend to be weak and distant, and to
LO when in metropolitan areas or where stations tend to be strong and local.
Stereo Symbol
Stereo symbol turns on if a
station with an incoming signal of at least 20 is received.
The unit gradually switches between mono to stereo automatically.
14