Bosch RA1181 - Manual (Page 15)

15
Router Table Assembly
Router Router Hole Fasteners Mount
Brand Model Pattern Required Type
Bosch 1613 series A 1/4-20 x 1 1 ⁄
2
″ Pan-head Phillips machine screws (36), 2
washers (27), and 1/4-20 nuts (26)
Bosch 1617 series (fixed B #10-24 x 3/4 ″ Pan-head Phillips machine screws (37) 1
base models only)
Bosch 1619EVS C 1/4-20 x 1 1 ⁄
2
″ Pan-head Phillips machine screws (36), 2
washers (27), and 1/4-20 nuts (26)
Craftsman Most Craftsman E 5/16-18 x 3/4 ″ Pan-head Phillips machine screws (39) 1
1/2 ″ collet routers
DeWalt DW616, DW618 B #8-32 x 3/4 ″ Pan-head Phillips machine screws (38) 1
(fixed base only)
Hitachi M12VC B #10-32 x 3/4 ″ Pan-head Phillips machine screws (35) 1
Makita RF1100, RF1101 B #10-24 x 3/4 ″ Pan-head Phillips machine screws (37) 1
Milwaukee 5615, 5616 B #10-24 x 3/4 ″ Pan-head Phillips machine screws (37) 1
Porter Cable 690 series, B #10-24 x 3/4 ″ Pan-head Phillips machine screws (37) 1
7529 plunge router,
and 892–895 series
(fixed base only)
Ryobi R161, R162 E 5/16-18 x 3/4 ″ Pan-head Phillips machine screws (39) 1
ATTACH ROUTER TO MOUNTING PLATE
(Figs. 9 and 10)
1. Remove the plastic subbase from your router
(Fig. 9).
2. If your router has its own dust extraction hood that
mounts to the top of the metal router base and you
want to use it under the router table, this is a
convenient time to install it.
3. Using Chart 1, determine the hardware and mount
type for your router.
• For most router models, the screws are driven into
threaded holes in the router’s base (mount type 1).
• For some router models, the screws go all the way
through the base and are fastened with washers
and nuts (mount type 2).
The top and front of the mounting plate is determined
by the location of the guide pin holes. These holes
are to the right of the bit opening.
4. Refer to the mounting plate guide (Fig. 8) on page 14
and align the appropriate mounting plate holes for
your router to the router base holes. Make sure that
the depth adjustment controls on the router face the
front of the mounting plate.
5. Mount your router to the mounting plate (Fig. 10).
FIG. 9
REMOVE
SUBBASE
FIG. 10
CHART 1