Blaupunkt HAMBURG MP57 - Manual (Page 15)

76
Startup
Close the control panel.
The display briefl y shows "READING DISC".
Next, the following appears:
The audio CD display if an audio CD is
inserted.
The MP3 display if an MP3 or WMA CD
is inserted.
The CD starts playing.
Selecting the CD as audio source
You can select an inserted CD as audio
source:
Press the SOURCE button > repeated-
ly until the desired display appears.
Note:
The CD mode can be selected only if a
readable CD is inserted.
To operate the audio CD display, please read
the chapter "CD mode (audio)".
To operate the MP3 display, please read the
chapter "CD/USB mode (MP3/WMA)".
Switching the device on/off
The device is switched on or off with the igni-
tion. The introductory animation starts and
can be cancelled with the
MENU/OK button
< . The device plays the audio source you
previously listened to.
To manually switch on the device:
Press the On/Off button 3 .
u
•
•
u
u
To switch off the device:
Press and hold the On/Off button 3 for
approx. two seconds.
Note:
To protect the vehicle battery if the igni-
tion is switched off, the device automati-
cally switches off after one hour.
Adjusting the volume
DANGER!
High volume
Excessive volume can damage your hear-
ing and you may fail to hear acoustic warn-
ing signals!
The devices mutes itself while it chang-
es the CD in the CD changer or the au-
dio source. During this mute phase, the
volume may be changed, but it is not
audible. Do not increase the volume
during a mute phase.
Always set the device to a moderate
volume.
Turn the volume control 4 .
The current volume is shown on the dis-
play and used for all audio sources.
Notes:
The volume can also be changed
during a phone call/navigation an-
nouncement using the volume control
u
ь
ь
u
•
02_BA_Hamburg_gb.indd 76 02_BA_Hamburg_gb.indd 76 26.03.2007 11:34:02 Uhr 26.03.2007 11:34:02 Uhr