beautypg.com

Speaker wires, Speaker connection polarity, Connecting the speakers – Boston Acoustics Indoor / Outdoor Speaker User Manual

Page 3: Mounting the speakers

background image

The SoundWare speakers pivot on their mounts.

Vertically they can go from facing straight out to being

tilted down 40 degrees. When the fl at wall mounting

bracket is used they can pivot side to side 20 degrees.

(Note: Corner mounting will not allow the speaker to

pivot side-to-side.) Loosen the pivot set screw on the

front of the pivoting ball mount, pivot the speaker into

position and retighten the screw.

Speaker Wires

For short runs of less then 20 feet or so you can use 16 gauge wire. But typically you should use

heavier 14 gauge wire. That is good enough for runs up to 50 feet or so. For runs of more than 50 feet

use 12 gauge wire.

Speaker Connection Polarity

All the speakers in a system must be hooked up with the same polarity or “in phase.” The terminals on

the SoundWare speakers are color coded to identify the “+” (red) and “–” (black) connections. All wire

is marked in some way so you can tell one conductor from the other. The marking may be a ridge

molded into the insulation of one conductor, or it may have a stripe on the insulation, or it may be

color coded. Use the marking on the speaker wires to be sure that the “+” terminal of the amplifi er is

connected to the “+” terminal of the speaker, and “–” is connected to “–”, at every connection.

Connecting the Speakers

Separate the two conductors of the wire. Remove

about 3/8” of insulation from the end of the wire. Push

down on the top of the terminal to open the hole for

the wire. Insert the wire and release the terminal to

secure it. Be sure there are no loose strands of wire.

Note: there is a channel in the back of the speaker for

the wire, to keep it neat and out of sight.

«ˆЫœМГК
`œЬ˜К{дc

«ˆЫœÌÃÊÓäc
i>V…ÊÜ>ЮК

*ˆЫœМК-iМ

-VÀiÜ

£

Ó

Mounting the Speakers

Once you have the bracket mounted and the speaker

connected the rest is easy.

1 Put the rounded end of the speaker mount in the

bracket and slide it down to lock it in place.

2 Optional – Insert and tighten the screw to secure

everything.

En

E

N
G

L

I

S

H