Buffalo Technology WLE-POE-S - Manual (Page 5)

5
FCC Statement
This equipment has been tested and found to comply with the limits for a class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference, in which case, the user will be required to correct the interference at
his own expense.
◗ All rights for this setup guide are owned by Buffalo INC. No part of it may be
transmitted, reproduced, or revised without expressed permission from BUFFALO
INC.
◗ The names of other products used in this manual are trademarks or registered
trademarks. Trademark symbols are not indicated in this setup guide.
◗ Specifications, designs and other descriptions in this manual are subject to
change without notice.
◗ This setup guide has been carefully prepared, however, feel free to contact
technical support if you have any questions or problems.
In addition, please note that Buffalo INC. shall not be liable for any expenses
incurred due to damage or loss arising from use of this product, even though
BUFFALO INC. has been advised of the possibility of such damage.
◗ This product is designed for home or office use as a general-purpose OA
device. BUFFALO INC. shall accept no liability for any damage incurred by using
the product for any other purpose.
FCC Statement
* Do not use the product for applications that must comply with high safety
requirements, such as medical instruments or any systems directly or
indirectly related to saving or sustaining life.
* If using the product for applications with devices and computer systems
requiring higher reliability than general-purpose OA devices, be sure to
configure the system with an appropriate safety design and measures
against failure.