Burley LADY BUG - Manual (Page 4)

B U R L E Y T R A I L E R O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N U A L B U R L E Y T R A I L E R O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N U A L
11. Make sure the center bolt on the cross
brace bar aligns with the center line of
the wheel. If it is not aligned, loosen the
right bolt
(a), release the bar quick-release
lever (b), and adjust the bar from side to
side until the center bolt is aligned with the
center of the wheel. Retighten the bolt and close
the bar quick-release lever. Engage the Jogger brake
by pushing the brake release lever
(c), toward the
wheel until it is parallel with the wheel (you may need
to push the brake pads together).
12. Now remove the lower snap screw on the right side of
the trailer. Place the brake clip over the hole, reinsert the snap screw
and tighten the screw. For the ’04–’06 d’lite
™ and ’05+ Encore ™ , repeat
for upper snap screw.
13. For ’07+ trailers, loosen the knob on the upper right side of the handlebar
mount. Remove the outer plastic plate. Thread the brake cable along the
inside of the handlebar and through the inner plastic plate, above the
screw hole. Place the outer plate back into place, and tighten the knob.
14. Make sure your handlebar is at the right height for jogging. If necessary,
remove and turn the handle upside down for a different height.
15. Push the foam on the handlebar to either side and clamp the brake lever
to the handlebar, twisting it up or down into a comfortable position.
16. Make your final adjustments.
Check that the wheel is
aligned with the frame. If it
is not, loosen the bolts on the
sides of the wheel dropouts,
align the wheel and then
tighten the bolts. If the brake
assembly is not centered on
the wheel, loosen the center
bolt on the bar, make the
adjustment and tighten the
bolt. Also, make sure the
brake pads are centered on the wheel rim. If they are not, loosen the
bolts on the back of each brake pad, adjust to center the pads on the
rim, and tighten the brake pad bolts. If you have any questions about
these adjustments, please contact your Authorized Burley Dealer.
Using Your Jogger
Test your Jogger and become comfortable with it before using it with your
children. Secure your children safely as explained in your trailer manual, and
never leave them unattended in the Jogger. While using the Jogger you have
two braking options: a brake mounted on the handle bar for slowing down while
you’re running, and a parking brake on the rear of the trailer body. Engage the
parking brake whenever you take your children in and out of the trailer.
Never leave your children unattended in the Jogger. Always use your
handle bar tether. Failure to do so may cause you to lose control of the
Jogger, which may cause an accident and injury.
WARNING
Maintenance
Make sure all of the nuts and bolts are secure and that the brakes are work-
ing properly. If you have any questions about the operation and maintenance
of your Jogger, please contact your Authorized Burley Dealer.
Burley Jogger Kit Parts List
and Diagram
1. Jogger Assembly
2. Jogger Wheel
3. Wheel Quick-Release Lever
4. Brake Cable Clips
5. Snap Screw
1
2
3
4
5