Burley LADY BUG - Manual (Page 3)

B U R L E Y T R A I L E R O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N U A L B U R L E Y T R A I L E R O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N U A L
physician should evaluate anyone who is of questionable developmental age
for using this Jogger. Never carry a child whose sitting height is above the
roll bar, because their chance of injury is significantly higher in the event of
a tip over.
Jog and Walk on Suitable Surfaces
Use the Jogger only on paths that are meant for jogging or walking. Do not
use it on steep slopes, which make the Jogger unstable. You should be able
to maintain traction and control at all times. Do not maneuver the Jogger
over stairs or other obstacles while your child is in it. Never use your Jogger
with inline or roller skates.
Hardware Bag Contents and Tool List
Hardware Bag Contents:
(1) Quick-release lever
(1) Brake cable clip
(1) Screw
(1) Warranty Card
(1) Burley Owner’s Manual
tools Required: Two 7/16” wrenches (or crescent wrenches)
Small Phillips screwdriver
Installing the Jogger on Your Trailer
Only install the Jogger when the trailer is unoccupied. Engage the parking
brake on your trailer and detach the trailer tongue. (See your trailer manual
for instructions for removing the tongue.)
1. Place the jogger unit in front of the trailer, with the brake on the
bottom and the brake pads in the forward position.
2. Insert the jogger arms into the front tongue mounts on both sides of
the trailer.
3. Continue to push the jogger arms into the rear tongue mounts.
4. Line up the holes in the mounting arms with the holes in the rear
tongue mounts.
5. Insert the retaining pins through the
holes and lock them into place.
Never operate the Jogger without the
retaining pins locked into place.
Unlocked retaining pins can cause the
mounting arms to loosen or detach,
causing an accident resulting in seri-
ous injury or death.
WARNING
6. Release the Jogger brake by pushing the lever (a) towards the trailer,
pushing the brake pads (b) together if necessary.
7. Insert the wheel quick-release lever
skewer through the hub of the wheel,
making sure there is a spring on either
side of the hub. Screw the nut on
loosely.
8. Place the wheel in the wheel dropouts.
9. With the wheel quick release lever handle perpendicular to the wheel,
tighten the nut so that you feel resistance halfway through closing the
lever. Do not tighten the quick-release lever by spinning the lever.
10. Close the quick-release lever. The lever should point to the rear
of the Jogger.
It is important that the wheel be
installed correctly. Contact your Autho-
rized Burley Dealer or Burley if these
instructions are unclear. An incorrectly
installed wheel could result in an ac-
cident and serious injury or death.
WARNING
Please verify that you have received all of the contents
listed. Do not proceed with assembly if any parts are missing; contact
Burley immediately for replacement parts.
IMPORTANT:
1
2 3
4
5 5