Liebherr LTM 1060-3.1 - Manual (Page 15)

LTM 1060-3. 1
15
The LICCON working range limiting
system
• Relief for the crane operator’s job by auto-
matically monitoring workspace restrictions
such as bridges, roofs, etc.
• Simple programming
• Four different limitation functions:
- Pulley-head height limitation
- Radius limitation
- Slewing angle limitation
- Edge limitation
The LICCON work planner
• Computer programme for planning,
simulating and documenting crane op-
erations on a PC
• Representation of all the crane’s load
charts
• Automatic search for suitable crane
based on entry of load, radius and lifting
height parameters
• Simulation of crane operations with
outline functions and supporting force
display
Intelligent crane control
For functional and safe crane operation:
the LICCON computer system
The soft and hardware of the mobile crane control is developed by Liebherr in-
house. The centre is the LICCON computer system (Liebherr Computed Control).
• Integrated LML load moment limiter
• Key components are in-house manufactured by Liebherr
• Guaranteed spare parts availability
• Worldwide proven under the most different climate conditions
• Operator friendly
• High reliability due to data bus technology
The second control generation LICCON2 is the result of a continuous
development by the Liebherr specialists and enables the adaption to the con-
stantly increasing demands of the markets due to its modern and future
oriented control.
for more efficient mobile crane jobs
• Lower fuel consumption
• Lower noise emissions
In “ECOmode” the crane driver sets
the required working speed using
the control lever. The LICCON2
control then calculates the perfect
engine speed for it. This value is set
on the crane engine using the en-
gine control unit. Fuel savings are
up to 10%.