Liebherr WTes 1753 Vinidor - Manual (Page 4)

Setting up
• Avoid locating the appliance it in direct sunlight or near heat sources such as an oven
or a radiator.
• The floor should be level and even. You can compensate for an uneven floor by ad-
justing the adjustable feet.
• Standard EN 378 specifies that the room in which you install your appliance must
have a volume of 1 m 3 per 8 g of R 600a refrigerant used in the appliance, so as to
avoid the formation of inflammable gas/air mixtures in the room where the appliance
is located in the event of a leak in the refrigerant circuit. The quantity of refrigerant
used in your appliance is indicated on the type plate on the inside of the appliance.
• The appliance is set to operate within specific ambient temperature limits according
to its climate rating. These temperature limits should not be exceeded. The correct
climate rating for your appliance is indicated on the type plate.
SN = +10°C to +32°C
SN - ST = +10°C to +38°C
Electrical requirement
Power supply (AC) and voltage at the operating point must comply with the details on
the type plate. The type plate is located on the top left-hand side on the inside of the
appliance. The socket must be fused with a 10 A fuse or higher, it must be away from
the rear of the appliance and must be easily accessible.
16
Dimensions
To compensate for any unevenness, adjust the height
of the feet with the open-ended wrench supplied.
Saving energy
- Always ensure good ventilation. Do not cover
ventilation openings or grille.
- Always keep fan louvres clear.
- Do not place appliance in areas of direct
sunlight or next to a stove, heater or similar
object.
- The energy consumption depends on the in-
stallation conditions, e.g. the ambient tempe-
rature.
- Keep the time the appliance is open to a
minimum.