Liebherr WTes 1753 Vinidor - Manual (Page 10)

Defrosting
The appliance defrosts automatically. The water that forms on the rear wall drains into
a reservoir at the back of the appliance and evaporates automatically through the com-
pressor heat.
Cleaning
Before cleaning always switch off the appliance. Pull out the mains plug or remove/
unscrew the fuse.
Do not use steam cleaners because of the risk of injury and damage.
• Do not use abrasive sponges or scourers, do not use concentrated cleaning agents and
never use cleaning agents containing sand, chloride or acid or chemical solvents, as
these would damage the surfaces and could cause corrosion.
• Use a glass cleaner to clean the glass surfaces and a commercially available stainless-
steel cleaning agent for the stainless-steel surfaces.
• Clean the inside and equipment with lukewarm water and a little detergent, with the
exception of the wooden trims on the grid shelves.
• Ensure that no cleaning water penetrates into the elec trical compo nents.
• Dry all parts well with a cloth.
• Do not remove the type plate from the inside of the appliance; it is important for
after-sales servicing.
• If the motor compartment becomes dusty, it should be cleaned. To do this, remove the
bottom ventilation plate as follows:
1 Remove the cover caps and screws.
2 Loosen (but do not remove) the left-hand
screw on the hinge bracket.
3 Remove the cover panel.
4 Remove the ventilation plate to the left.
The motor compartment can then be cleaned
with a vacuum cleaner.
After cleaning, replace the ventilation plate.
Make sure you re-tighten the screw 2 on the
hinge bracket properly.
22