Black & Decker TRos1500 - Manual (Page 6)

10 9
14. Plug into standard electrical outlet. Extra cord can be hung over cord
management hook behind unit (H).
Warning: Risk of electrical shock and fire. Do not allow cord to touch rear
surface of oven.
Caution: This appliance features a Save-A-Plug™ outlet receptacle to connect
smaller †SpaceMaker™ appliances such as the mini food processor / grinder or
can opener. Do not use this outlet for any other appliance!
Note: If you are connecting another †SpaceMaker™ appliance into the Save-A-
Plug™ outlet, make sure you can easily unplug the appliance after each use.
12. Your †SpaceMaker™ appliance is now ready for use!
OVERHANG MOLDING INSTALLATION
For cabinets with an overhang molding (see Illustration C)
Important: Always wear protective glasses or goggles to prevent injury when
drilling.
Note: Spacers are provided in case your cabinet has an overhang molding at the
front edge. Only use spacers on the rear screws of the appliance to ensure it is
level with the front.
1. Clear countertop under installation area to avoid getting on other appliances
or items. Open cabinets and remove contents to make mounting easier.
2. Clean both the underside and topside of the bottom panel of the cabinet.
3. Using a ruler, measure the thickness of the overhang molding
(J), accurately
noting the number for use in the following step.
Note: If you do not have a ruler, you may cut out the paper ruler provided on the
edge of your mounting template.
J
H
9. Hold hood in place, aligning front of hood with front edge of cabinet; drilled
holes on cabinet should be aligned with mounting holes on the hood.
10. Drop one of your screws through each of the washers covering the holes in the
cabinet, from inside the cabinet down.
Note: To determine which screws to use, you must have enough of the screw
exposed underneath the cabinet to properly thread the screw into the nut.
11. Screwing from inside the cabinet down into holes, tighten 4 screws in place to
secure hood to cabinet.
Note: Always tighten screws to ensure the appliance does not move or shake
during operation.
12. After the hood is secured, lift the toaster oven up to mount. Hook the mounting
tabs on the back of the oven over the mounting hooks at the back of the hood
(F).
Important: Do not put mounting hooks on hood through the mounting tabs on
the oven. You must hook the tabs up and over the hooks to properly hold.
13. Once the back hooks are secure, hook your fingers around the feet on the front
of the toaster oven (G). Pull forward and push up on the feet at the same time
to engage the front hooks.
F
G