Briggs & Stratton POWER BUILT 200000 - Manual (Page 10)

10 BRIGGSandSTRATTON.COM
This is an air cooled engine. Dirt or debris can restrict air flow and cause the engine to
overheat, resulting in poor performance and reduced engine life.
Use a brush or dry cloth to remove debris from the finger guard (A) (Figure 18). Keep
linkage, springs and controls (B) clean. Keep the area around and behind the muffler (C)
free of any combustible debris.
Storage
WARNING
Gasoline and its vapors are extremely flammable and explosive.
Fire or explosion can cause severe burns or death.
When Storing Gasoline Or Equipment With Fuel In Tank
•
Store away from furnaces, stoves, water heaters or other appliances that have
pilot lights or other ignition sources because they can ignite gasoline vapors.
Fuel System
Fuel can become stale when stored over 30 days. Stale fuel causes acid and gum
deposits to form in the fuel system or on essential carburetor parts. To keep fuel fresh,
use Briggs & Stratton FRESH START ® fuel stabilizer, available as a liquid additive or a
drip concentrate cartridge.
There is no need to drain gasoline from the engine if a fuel stabilizer is added according
to instructions. Run the engine for 2 minutes to circulate the stabilizer throughout the fuel
system. The engine and fuel can then be stored up to 24 months.
If gasoline in the engine has not been treated with a fuel stabilizer, it must be drained into
an approved container. Run the engine until it stops from lack of fuel. The use of a fuel
stabilizer in the storage container is recommended to maintain freshness.
Engine Oil
While the engine is still warm, change the engine oil.
Troubleshooting
Need Assistance? Go to BRIGGSandSTRATTON.COM or call 1-800-233-3723.
Specifications
Engine Specifications
Model 120000
Displacement 12.48 ci (205 cc)
Bore 2.688 in (68.28 mm)
Stroke 2.200 in (55.88 mm)
Oil Capacity 18 -- 20 oz (0.54 -- 0.59 L)
Gear Reduction Oil 80W-90
Engine Specifications
Model 150000
Displacement 15.24 ci (250 cc)
Bore 2.970 in (75.44 mm)
Stroke 2.200 in (55.88 mm)
Oil Capacity 18 -- 20 oz (0.54 -- 0.59 L)
Gear Reduction Oil 80W-90
Engine Specifications
Model 200000
Displacement 18.63 ci (305 cc)
Bore 3.120 in (79.24 mm)
Stroke 2.438 in (61.93 mm)
Oil Capacity 26 -- 28 oz (0.77 -- 0.83 L)
Gear Reduction Oil SAE 30
Engine Specifications
Model 210000
Displacement 20.85 ci (342 cc)
Bore 3.300 in (83.81 mm)
Stroke 2.438 in (61.93 mm)
Oil Capacity 26 -- 28 oz (0.77 -- 0.83 L)
Gear Reduction Oil SAE 30
Tune-up Specifications *
Model 120000, 150000
Spark Plug Gap 0.030 in (0.76 mm)
Spark Plug Torque 180 lb-in (20 Nm)
Armature Air Gap 0.010 - 0.014 in (0.25 - 0.36 mm)
Intake Valve Clearance 0.004 - 0.006 in (0.10 - 0.15 mm)
Exhaust Valve Clearance 0.009 - 0.011 in (0.23 - 0.28 mm)
Tune-up Specifications *
Model 200000, 210000
Spark Plug Gap 0.030 in (0.76 mm)
Spark Plug Torque 180 lb-in (20 Nm)
Armature Air Gap 0.008 - 0.012 in (0.20 - 0.30 mm)
Intake Valve Clearance 0.004 - 0.006 in (0.10 - 0.15 mm)
Exhaust Valve Clearance 0.009 - 0.011 in (0.23 - 0.28 mm)
* Engine power will decrease 3.5% for each 1,000 feet (300 meters) above sea level and 1% for each 10° F (5.6° C) above 77° F (25° C). The engine will operate satisfactorily at an
angle up to 15°. Refer to the equipment operator’s manual for safe allowable operating limits on slopes.
Common Service Parts n
Service Part Part Number
Flat Air Filter 491588, 5043
Flat Air Filter Pre-cleaner 493537, 5064
Oval Air Filter 697029, 5059
Oval Air Filter Pre-cleaner 273356
Fuel Filter 694485
Service Part Part Number
Fuel Additive 5041, 5058
Resistor Spark Plug 491055
Long Life Platinum Spark Plug 5066
Spark Plug Wrench 89838, 5023
Spark Tester 19368
n We recommend that you see any Briggs & Stratton Authorized Dealer for all maintenance and service of the engine and engine parts. Use only genuine Briggs & Stratton parts.
Not for Reproduction