Philips Casque hi-fi sans fil - Manual (Page 8)

8
English
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this
would invalidate the warranty.
Problem Remedy
No sound – Check if the AC/DC adapter is fully inserted into the
AC outlet and that its DC connector is properly inserted
into the 12 Volt DC input connector located at the rear
of the transmitter.
– Check if the headphone’s on/off switch is in the on
position.
– Headphone batteries running low. (See Headphone
power supply)
– Check if the audio source is switched on.
– Volume not adjusted. Adjust the volume on the audio
source/ headphone to a higher level.
– Make use of the SHC2000 transmitter. Some
transmitters already built into other equipment may not
be compatible with the SHC2000 headphone because of
the advanced technologies used in the SHC2000
headphone.
Distorted sound – Headphone batteries running low. (See Headphone
power supply)
– Check the volume on audio source/ headphone is not
set at too high a level. Reduce the volume.
– Distance from the transmitter is too large. Move closer
to the transmitter.
– Interference from fluorescent lamps/ other radio
sources. Move transmitter or headphone elsewhere.
– Make use of the SHC2000 transmitter. Some
transmitters already built into other equipment may not
be compatible with the SHC2000 headphone because of
the advanced technologies used in the SHC2000
headphone.
SHC2000_booklet 12-01-2006 11:05 Pagina 8