beautypg.com

Controls installation – Philips Casque hi-fi sans fil User Manual

Page 5

background image

English

5

Transmitter (figure 1)

1 IR transmitting LEDs – transmit audio

signal to IR headphone.

2 DC power – connect to the 12 Volt/

200 mA AC/DC adapter.

3 Power switch – power on/off switch.

4 3.5 mm stereo headphone audio

input – connects your IR transmitter to an
audio source.

5 Recharging input – connect the

recharge cable to the input.

6 Controls plate

Headphone (figure 2)

7 IR sensors – to receive IR waves from the

transmitter

8 Power indication – lights up when in use.

9 Power On/Off – slide the switch to the

on or off position to switch the headphone
on/off.

10 Volume – adjust volume to your desired

listening level.

11 Recharging indicator – lights up when

the recharging cable is connected between
the headphone and the IR transmitter.
Completely flat batteries will be fully
charged after about 16 hours.

12 Recharging input (figure 3) – connect

the recharging cable to the transmitter.
The recharging indicator on the headphone
must switch on, indicating that the
headphone is being recharged.

Transmitter power supply

IMPORTANT
Use only Philips SBC CS030/00
12 Volt/200 mA AC/DC adapter.
(For UK version: SBC CS030/05
12 Volt/200 mA AC/DC adapter)

1 Make sure the adapter’s rated voltage

corresponds to the mains socket voltage.

2 Connect the DC connector of the AC/DC

adapter to the 12 Volt DC power input
connector located at the rear of the
transmitter.

3 Connect the 12 Volt/200 mA AC/DC

adapter to the mains socket.
– Always disconnect the AC/DC adapter

if the transmitter is not to be used for
a long period of time.

Controls

Installation

Environmental Information

All redundant packing material has been omitted.We have done our best to make the
packaging easily separable into two materials: cardboard and polyethylene

Your unit consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packing
materials, exhausted batteries and old equipment.

SHC2000_booklet 12-01-2006 11:05 Pagina 5

This manual is related to the following products: