Philips Casque hi-fi sans fil - Manual (Page 6)

Installation Audio Connections
6
English
Headphone power supply
IMPORTANT
Only use R03/AAA NiMH batteries
(preferably Philips).
1 Check if the power button of the
IR headphone is in the on position.
2 Ensure the batteries are put in the battery
compartment correctly according to the
engraved polarity symbols.
3 To recharge the headphone’s rechargeable
R03/AAA NiMH batteries, first switch off
the headphone.Then connect the charge
cable between the headphone and the
transmitter (figure 3).The recharging
indicator will light up.
Note:
Completely flat batteries need
approximately 16 hours to recharge.
Always remove the batteries if the
headphone is not to be used for a long period
of time.
Batteries contain chemical substances,
so they should be disposed of properly.
Headphone battery
replacement (figure 4)
IMPORTANT
Only use R03/AAA NiMH batteries
(preferably Philips).
1 Open the headphone’s battery
compartment.
2 Take out the batteries and dispose of them
properly.
3 Insert new batteries. Only use R03/AAA
NiMH batteries (preferably Philips).
4 Make sure the batteries are correctly
inserted as indicated by the engraved
symbols in the battery compartment.
5 Close the battery compartment.
IMPORTANT
Before using the IR headphone for the
first time, please ensure that the
batteries are fully charged for about
16 hours.This will guarantee a longer
operating lifetime of the batteries.
SHC2000_booklet 12-01-2006 11:05 Pagina 6