Brother MOBILE PRINTER MW-140BT - Manual (Page 31)

16
Disposing of this printer
Before disposing of this printer, be sure to remove the built-in
lithium ion battery.
Removing the lithium ion battery
1
Turn off the printer, and
then disconnect the AC
adapter.
2
Using a screwdriver,
loosen the four screws at
the back of the printer,
and then remove the back
cover.
3
Disconnect the connector, and then remove the
lithium ion battery.
• Removing the back cover will void the warranty.
Do not remove the back cover unless the printer
is to be disposed of.
• The lithium ion battery is attached to the printer
with adhesive tape. When removing the lithium
ion battery, grasp it, and then pull it off of the
printer. Be careful not to pull on the cable.
• When unplugging the connector, do not pull on
the cable.
• There is a risk of explosion if the battery is
replace with an incorrect battery type. Dispose of
used batteries according to local regulations con-
cerning special waste.
Lithium ion
battery
Connector