Philips EnergyUp Lampe Energylight - Manual (Page 20)

1 Disconnect the appliance from the mains and remove the appliance
plug.
2 Switch on the appliance and leave it on until it goes out
automatically.
3 Peel off the rubber material at the bottom rear end of the
appliance (Fig. 17).
4 To open the housing, place the tip of a flat-head screwdriver on the
break line with one hand. This line is indicated on the back of the
housing. Then hit the top of the screwdriver handle with a hammer
until the housing breaks open.
5 Repeat this in several spots along the break line until a whole
section of the housing is loose. Remove this section with the tip of
the screwdriver (Fig. 18).
6 Remove the rechargeable battery from the housing with the tip of
the screwdriver (Fig. 19).
Note: Do not try to remove the rechargeable battery with your fingers.
The plastic edges of the housing may be sharp.
Always wear gloves when you handle the rechargeable battery.
It may be damaged.
, You have now successfully removed the rechargeable battery from
the appliance.
Specifications
Model HF3430
Electrical
Rated input voltage adapter
100-240 VAC
Rated input frequency adapter 50-60 Hz
No-load power adapter <0.1 W
Rated output voltage adapter 9 Vdc
ENGLISH 20