Beko WMD 78144 - Manual (Page 23)

EN 23
buttons for 3 sec.
“C:OFF” (Child-proof lock is deactivated)
label appears on the screen.
Ending the program through
canceling
“Start/Pause/Cancel” button (Figure
2-10) is pressed for 3 seconds to cancel
the program. Start symbol (Figure
3-13j) will flash during cancellation.
After cancellation, the symbol of the
corresponding step at which the
cancellation was made will remain lit and
“ End ” will appear on the screen.
Program in rinse hold mode
• This process is shown with the
flashing Spin Symbol (Figure 3-13c)
and the lit up Standby Symbol
(Figure 3-13k).
If you wish to spin when the machine is
in this mode:
Adjust the spin speed. Press “Start/
Pause/Cancel” button (Figure 2-10).
The program continues, pumps out the
water and spins. The Standby Symbol
(Figure 3-13k) fades out and Start
Symbol (Figure 3-13j) lights up.
If you want to discharge the water only
without spinning:
Press “Start/Pause/Cancel” button
(Figure 2-10). The Standby symbol
(Figure 3-13k) will fade. The Start symbol
(Figure 3-13j) will light up. The program
continues and only drains the water.
End of program
When the program is finished, the
symbols of the relevant steps will remain
lit up and the auxiliary function, spin and
temperature data selected at the start-
up of the program will remain selected.
“End” will appear on the display.