Black & Decker Linea Pro ITM90545036 - Manual (Page 26)

TROUBLESHOOTING GUIDE
ENGLISH
SPECIFICATIONS
VOLTAGE
AR 220V ~ 50Hz
B2C 220V ~ 50Hz
B3 120V ~ 60Hz
POWER 2000W
NO-LOAD SPEED
AR, B2C, B3 n
0
3800/min (3800 rpm)
TROUBLE! TOOL WILL NOT START
WHAT’S WRONG?
1. Tool not plugged in.
2. Fuse blown or circuit breaker tripped.
3. Cord damaged.
4. Brushes worn out.
WHAT TO DO…
1. Plug in saw.
2. Replace fuse or reset circuit breaker.
3. Have cord replaced by authorized service center.
4. Replace brushes.
TROUBLE! TOOL MAKES UNSATISFACTORY CUTS
WHAT’S WRONG?
1. Glazed wheel.
2. Workpiece incorrectly placed or clamped.
WHAT TO DO…
1. Dress the wheel or replace with a new one.
2. Firmly clamp and support workpiece.
TROUBLE! BLADE DOES NOT COME UP TO SPEED
WHAT’S WRONG?
1. Extension cord too light or too long.
2. Low voltage.
3. Low generator voltage.
WHAT TO DO…
1. Replace with adequate size cord.
2. Contact your electric company.
3. Check generator output voltage. Reduce number of
tools powered by the generator.
WHAT’S WRONG?
1. Damaged wheel.
2. Workpiece not clamped properly.
WHAT TO DO…
1. Replace wheel.
2. Refer to
Material Clamping and Supporting page 24.
TROUBLE! TOOL VIBRATES EXCESSIVELY DURING CUT
WHAT’S WRONG?
1. Fence not adjusted correctly.
2. Wheel is not square to fence.
3. Excessive force used to make cut.
4. Work piece moving.
WHAT TO DO…
1. Check and adjust. See Fence Operation on page 24.
2. Check and adjust.
3. Reduce cutting force, let the wheel do the work.
4. Clamp workpiece securely. See
Material Clamping
and Supporting, page 24. Make sure material is
laying flat against the base.
TROUBLE! DOES NOT MAKE ACCURATE CUTS
WHAT’S WRONG?
1. Fence slipping or workpiece incorrectly placed or
clamped.
2. Vise too loose
3. Excessive cutting force.
WHAT TO DO…
1. See Material Clamping and Supporting, page 24.
2. Tighten vise clamping.
3. Reduce cutting force.
TROUBLE! MATERIAL MOVES DURING CUT
26