Black & Decker Linea Pro ITM90545036 - Manual (Page 23)

ENGLISH
FEATURES (FIG. 1, 4)
POWER SUPPLY
Be sure your power supply agrees with the nameplate marking. A voltage decrease of more than 10% will
cause a loss of power and overheating.
CUTTING CAPACITY
The wide vise opening and high pivot point provide cutting capacity for many large pieces. Use the cutting
capacity chart to determine total maximum size of cuts that can be made with a new wheel.
CAUTION: CERTAIN LARGE, CIRCULAR OR IRREGULARLY SHAPED OBJECTS MAY REQUIRE
ADDITIONAL HOLDING MEANS IF THEY CANNOT BE HELD SECURELY IN VISE.
CAUTION: DO NOT CUT MAGNESIUM WITH THIS TOOL.
MAXIMUM CUTTING CAPACITY
NOTE: Capacity shown on chart assumes no wheel wear and optimum fence position.
STANDARD EQUIPMENT
1 14" Metal Cutting Abrasive Wheel
1 Wheel Wrench
1 Instruction manual
TO CARRY (FIG. 1)
Fold down unit to position where you can carry the saw. Hook lock chain (A) to lock arm down.
UNLOCKING (FIG. 1)
To unlock tool and raise head, depress motor arm slightly and unhook lock chain (A) out. Motor arm will then pivot upward.
SPARK DEFLECTOR ADJUSTMENT (FIG. 1)
To best deflect sparks away from surrounding persons and materials, loosen the screw (B), adjust the spark
deflector (C) and then retighten screw. Do not allow cordset to come into contact with deflector or sparks as
damage to cordset may occur.
Workpiece Shape:
90° Cutting Angle
45° Cutting Angle
A = 4-7/8"
(125mm)
A= 4-1/2"
(115mm)
A = 4-1/2"
(115mm)
A = 3-13/16"
(98mm)
A x B
4-1/2" x 5-1/8"
(115mm x 130mm)
4" x 7-5/8"
(102mm x 188mm)
3" x 7-3/8"
(76mm x 229mm)
4-1/2" x 3-13/16"
4-1/8" x 3-3/4"
(105mm x 95mm)
A = 4-1/2" x 5-3/8"
(115mm x 137mm)
A = 3-13/16"
3-3/4"
(95mm)
A. Lock Chain
B. Spark deflector screw
C. Spark deflector
D. Base
E. Fence
F.
Vise
G. Flat Wrench
H. Crank
I. Vise Lever
J. Wheel
K. Guard
L.
Spindle Lock
M. Depth Stop Bolt and Jam Nut
N. Trigger Switch
O. Padlock Hole
P.
Fence Bolts
23