Philips Éveil Lumière - Manual (Page 8)

preparing for use
installing the appliance
Note: You can also use the Wake-up Light without the base. You only have to install the base when you
want to use the Wake-up Light in combination with your iPod/iPhone.
1 Hold the Wake-up Light above the base.
Note: Make sure that the iPod/iPhone station is on the left side of the Wake-up Light.
2 Align the holes in the bottom of the Wake-up Light with the pins on the base. Then push the
Wake-up Light onto the pins (‘click’). (Fig. 5)
- To remove the base, turn the Wake-up Light upside down and push the release slide on the
bottom of the base in the direction of the arrow. Then pull the base off the Wake-up
Light. (Fig. 6)
3 Place the Wake-up Light 40-50cm from your head, for example on a bedside table (Fig. 7).
4 Put the plug in the wall socket.
- The hour indication on the display starts flashing to indicate that you have to set the clock
time (Fig. 8).
setting the clock
1 Move the middle function selector (SET) up or down to select the hour.
Note: You can only do this when you are in the set clock menu and when the hour indication flashes. If
this is not the case, press the middle function selector (SET) two times. You are now in the set clock
menu.
2 Press the middle function selector (SET) to confirm.
, The minute indication starts flashing (Fig. 9).
3 Move the middle function selector (SET) up or down to select the minutes.
4 Press the middle function selector (SET) to confirm.
, The appliance leaves the menu and the display shows the set clock time.
The appliance is now ready for use.
Note: Every time you remove the plug from the wall socket for more than approximately 15 minutes, you
have to set the clock time again in the way described above. To change the set clock time when the plug
is still in the wall socket, see section ‘Menu functions of middle function selector (SET)’ in chapter ‘Using
the appliance’.
using the appliance
How to use the 3 function selectors
The control panel has three function selectors. With these selectors you can set all functions of the
appliance.
Note: If you do not operate the function selector for 5 seconds when you are in the menu (SET), the
appliance automatically leaves the menu and displays the clock time again.
You can operate the function selectors in the following way:
1 Press one of the function selectors to activate the selection mode.
2 Move the function selector up or down to select a setting.
Note: If you keep the function selector in upward or downward position for 2 seconds, the settings change
more quickly.
EnglisH 8