Philips Éveil Lumière - Manual (Page 10)

1 Push the control lever down to the middle position to switch on the alarm. (Fig. 11)
, The hour indication of the alarm time flashes (Fig. 12).
, To adjust the time, follow steps 2 to 5. If the alarm time is correct, just wait a few seconds.
2 Move the middle function selector (SET) up or down to select the hour.
Note: You can only do this when the hour indication flashes. If this is not the case, push the control lever
up and down again to enter the alarm time mode. You can also set the alarm time in the menu. See
section ‘Menu functions of middle function selector (SET)’ in this chapter.
3 Press the middle function selector (SET) to confirm.
, The minute indication of the alarm time starts to flash (Fig. 13).
4 Move the middle function selector (SET) up or down to select the minutes.
5 Press the middle function selector (SET) to confirm or wait for a few seconds.
, The appliance leaves the menu and the display shows the clock time.
The alarm time is now set.
switching off the alarm
To switch off the alarm function, push up the control lever to the top position.
Note: The lamp stays on. You can switch off the lamp by pressing the top function selector.
Note: The alarm (sound and/or light) automatically switches off after 90 minutes.
setting the alarm sound
See section ‘Menu functions of middle function selector (SET)’ above.
You can choose one of the following sounds:
- Music from your iPod/iPhone (see section ‘Using your iPpod/iPhone as alarm sound’
below) (Fig. 14).
- Radio (Fig. 15)
- Birds (Fig. 16)
- Beep (Fig. 17)
- African jungle (Fig. 18)
- Wind chimes (Fig. 19)
using your ippod/iphone as alarm sound
1 Select a wake-up song (or album/playlist) on your iPod/iPhone.
, this song starts playing.
2 Set your iPod/iPhone to pause position or switch it off.
, When you have selected your iPod/iPhone as alarm sound, the paused song starts playing at
the set alarm time.
Note: If the iPod/iPhone is unable to play the selected song, you hear the bird alarm sound of the Wake-
up Light at the set alarm time
snoozing
1 Push down the control lever to the bottom position when the alarm goes off. (Fig. 20)
, The lamp continues to be on at the selected intensity level, but the alarm sound stops. After
9 minutes, the wake-up sound is automatically played again.
Note: The 9-minute snooze time is fixed. This time cannot be adjusted.
Note: If you push down the control lever with too much force, it may jump back to off position.
EnglisH 10