Philips TransDock micro - Manual (Page 6)

11
EN
G
LI
SH
10
3. Leave your PhilipsTransDock micro on the desired
preset and tune your radio to the corresponding
frequency to begin broadcasting.
Audio Level
Audio Level gives you the option of selecting the
volume output level that fits your particular audio.Turn
the dial right or left to select from: Low, Medium or
High.
Listening Mode
Listening Mode allows you to choose between Mono
and Stereo.Your PhilipsTransDock micro defaults to
Mono for optimal transmitter performance.To learn
more about Listening Mode please read Getting the
Best Sound Quality.
Brightness Time
BrightnessTime allows you to change the length of time
that your PhilipsTransDock micro’s display screen stays
active. Scroll through to select:Always On, 2 seconds, 5
seconds, 10 seconds, 15 seconds, or 20 seconds
Brightness Level
Brightness Level controls the brightness of the OLED
display while your PhilipsTransDock micro is active.To
adjust brightness, turn the dial right for higher intensity
and left for lower intensity.
Getting the best sound quality
• Use IntelliTune to automatically find the optimal
frequency to broadcast your iPhone over your car’s
FM stereo.Then, tune your car’s FM stereo to the
frequency displayed on your PhilipsTransDock micro.
• Choose between Mono and Stereo in Listening
Mode: Mono allows for much better transmitter
performance, while Stereo allows for the best sonic
musical performance.
D
Note: If static or distortion increases, switch to
Mono for the best transmitter performance possible.
• To get the best initial performance from your Philips
TransDock micro, it is very important that you set
your iPhone EQ to Off and adjust your car’s bass and
treble controls to 0.Then you can experiment with
adding bass and treble to your desired level.
Dim Level
Dim Level controls the brightness of the OLED
display while your PhilipsTransDock micro is inactive.
Turn the dial right for higher intensity and left for
lower intensity or completely off.
Reset Settings
Reset Settings allows you to revert back to the factory
settings.To do so, press the dial when on Reset
Settings.Your PhilipsTransDock micro will ask you if
you are sure you would like to reset your settings.
Press the dial once to accept, or turn right or left to
return to the Settings Menu.