Belkin F1U119 - Manual (Page 17)

Windows ® 95/98 (continued)
13
Assigning Pre-Installed Printers To The Belkin AutoSwitch
Virtual Ports:
• If you are trying to add your printers to Windows ® and it is not listed in
the default, Add Printer Wizard, you will have to use the software that
came with your printer to install the printer. Follow the instructions that
came with your printer, then REBOOT YOUR COMPUTER.
• If your printers are already installed in Windows ® , all you have to do is
to change the port assignment from LPT1 (or any other LPT port) to the
virtual AutoSwitch ports.
Example:
You installed two DeskJets and two LaserJet ™ s in Windows ® . The DeskJets
are connected to Port A and Port C of the AutoSwitch, and the LaserJet ™ s
are connected to Port B and Port D of the AutoSwitch, as shown in the
diagram below:
LaserJet ™ DeskJet
(new switch type)
En
P73074/F1U119/AM/man.qxd 4/19/00 4:25 PM Page 13