Philips Éveil Lumière - Manual (Page 9)

You can choose a light intensity between 1 and 20.
Note: It takes approx. 1 second for the lamp to go on. This is normal, the lamp needs to heat up.
Note: The light intensity you have selected is automatically set as the light intensity level for the alarm as
well.
Tip: When you use the appliance for the first time, set the light intensity to 20. The moment you wake up,
check which light intensity level the appliance has reached by slightly moving the top function selector up
or down. When you do this, the current alarm light intensity level appears on the display. Set the alarm
light intensity to this level for the next day.
2 To switch off the lamp, press the top function selector again.
Note: When you want to check the light intensity without switching on the lamp, you can also move
the top function selector up or down to select a setting without pressing the function selector first.
setting the alarm
When you set the alarm, you choose an alarm time and the type of sound you want to wake up to.
The alarm is set when the alarm symbol is visible on the display. The light intensity slowly increases
to the selected level during the last 30 minutes before the set alarm time. The sound slowly
increases in 90 seconds to the selected level after the set alarm time.
Note: You can set the light intensity by turning the top function selector up or down and you can set the
alarm volume by moving the bottom function selector up or down. If you do not want to wake up to the
lamp or to a sound, select a light intensity or volume level of 0. See sections ‘Using the lamp’ and ‘Radio/
Volume’ in this chapter.
1 Push the control lever down to the middle position to switch on the alarm. (Fig. 8)
, The hour indication of the alarm time flashes (Fig. 9).
, To adjust the time, follow steps 2 to 5. If the alarm time is correct, just wait a few seconds.
2 Move the middle function selector (SET) up or down to select the hour.
Note: You can only do this when the hour indication flashes. If this is not the case, push the control lever
up and down again to enter the alarm time mode. You can also set the alarm time in the menu. See
section ‘Menu functions of middle function selector (SET)’ in this chapter.
3 Press the middle function selector (SET) to confirm.
, The minute indication of the alarm time starts to flash (Fig. 10).
4 Move the middle function selector (SET) up or down to select the minutes.
5 Press the middle function selector (SET) to confirm or wait for a few seconds.
, The appliance leaves the menu and the display shows the clock time.
The alarm time is now set.
switching off the alarm
To switch off the alarm function, push up the control lever to the top position.
Note: The lamp stays on. You can switch off the lamp by pressing the top function selector.
Note: The alarm (sound and/or light) automatically switches off after 90 minutes.
setting the alarm sound
See section ‘Menu functions of middle function selector (SET)’ above.
You can choose one of the following sounds:
- Radio (Fig. 11)
- Birds (Fig. 12)
- Beep (Fig. 13)
- African jungle (Fig. 14)
EnglisH 9