Assembly – Bolens 12228 User Manual

Page 5

Assembly

Section

INTRODUCTION

Carefully read these instructions in their entirety before you
attempt to assemble or operate your new equipment.

The Border Edger Attachment (D, Figure 1) does not need to be
installed until you are ready to do edging projects (refer to
instructions in Section 4).

UNPACKING INSTRUCTIONS

1. Inspect your machine immediately. If you find or suspect
damage to the carton or contents, contact your local authorized
dealer for assistance.

2. Remove any packing material. Check for loose parts before
discarding the packing material or carton. Loose parts include
the following:

(1) Wheel (for edging)
(1) Edger Tine
(2) *Long Bushings
(1) *Short Bushing

*Packed in a separate plastic bag.

3. Perform the assembly on a clean, level surface. Be careful
not to severely bend any of the control cables on the unit.

ASSEMBLY STEPS

STEP 1: Unfold and Adjust Handlebars

IMPORTANT: Be careful not to pinch any control cables. Push
the cables out and away before unfolding the handlebars.

1. Loosen the two handlebar knobs (A, Figure 1) and unfold the
handlebars into the operating position. Do not use force — if
there is binding, continue to loosen the knobs.

2. There are two height setting holes in the upper handlebar.
The unit is shipped with the handlebar knobs in the lowest
height setting holes. If this height is correct for you, simply
tighten the two handlebar knobs. If desired, reposition the han-
dlebar knobs, mounting screws and washers in the other set of
holes.

3. Check the six (6) plastic ties (C, Figure 1). The ties must be
positioned as shown.

NOTE: There is only one handlebar storage position – folded
over and down as originally shipped.

STEP 2: Inspect and Tighten Hardware

Check all bolts and screws on your unit and tighten as needed.

Tools Needed to Check for Loose Hardware:

• Adjustable wrench
• Slotted-head screwdriver
• Phillips-head screwdriver
• 7/16" socket and extension (to check hardware on handlebar)

STEP 3: Add Motor Oil to Engine

IMPORTANT: The engine is shipped without oil in the
crankcase. Do not start the engine without first adding motor
oil. Severe engine damage will result if the engine is run without
motor oil.

1. Refer to the separate Engine Owner’s Manual for motor oil
specifications and capacities.

2. Add oil as described in the Engine Owner’s Manual (the
engine is a vertical type, GX 31 model).

Figure 1

To prevent personal injury or property damage, do not start
the engine until all assembly steps are complete and you
have read and understand the safety and operating instruc-
tions in this manual.

WARNING