BenQ MP723 - Manual (Page 44)

Operation 44
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker. Be sure
you have made a correct connection to the projector audio input. See
"Connection" on page
18 for how the audio input is connected.
Muting the sound
To temporarily turn off the sound,
1.
Press MENU/EXIT and then press / until the SYSTEM SETUP: Advanced menu
is highlighted.
2. Press to highlight Audio Settings and press Mode/enter on the projector or ENTER
on the remote control. The Audio Settings page displays.
3. Highlight Mute and press / to select On.
Adjusting the sound level
To adjust the sound level,
1.
Repeat steps 1-2 above.
2. Press to highlight Volume and press / to select a desired sound level.
Turning off the Power on/off ring tone
To turn off the ring tone,
1.
Repeat steps 1-2 above.
2. Press to highlight Power on/off ring tone and press / to select Off.
The only way to change Power on/off ring tone is setting On or Off here. Setting the sound
mute or changing the sound level will not affect the Power on/off ring tone.
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
• Menu Display Time in the SYSTEM SETUP: Advanced > Menu Settings menu sets the
length of time the OSD will remain active after your last button press. The time length
ranges from 5 to 30 seconds in 5-second increments. Use
/ to select a suitable time.
• Menu Position in the SYSTEM SETUP: Advanced > Menu Settings menu sets the OSD
position in five locations. Use
/ to select a preferred position.
• Language in the SYSTEM SETUP: Basic menu sets your familiar language for the On-
Screen (OSD) Menus. Use
/ to select your language.
• Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be
displayed during projector start-up. Use
/ to select a screen.