beautypg.com

Notice, Caution – Bissell 6393 Series User Manual

Page 6

background image

6.

Attach vacuum hose and tools (continued)

4.

Slide the extension wand and crevice tool
together into the storage clip as shown.

5.

Slide the dusting brush/upholstery tool into
the storage clip as shown.

6.

Attach the TurboBrush by snapping it onto
the top cap of the upper tank.

Power switch

The Power Switch is located just below the
handle on the front of the vacuum. Push the
rocker switch “ON” (I) to vacuum, and “OFF” (O)
when cleaning is complete.

Handle positions

Press the handle release pedal, located on the
lower left side of the vacuum, with your foot to
place your vacuum into one of three cleaning
positions.

1. Upright

For storage and above floor

cleaning with tools.

2.

Normal Cleaning – Press handle
release pedal once. Position used
for most household floor cleaning tasks.

3.

Low Cleaning – With the vacuum in
normal cleaning position, press handle
release pedal again. Use for reaching
under low furniture such as tables,
chairs or beds.

A

ssembling your vacuum (continued)

6

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1

NOTICE:

For above floor cleaning, the
floor brush continue to rotate but
is raised above floor. To prevent
carpet damage, do not lean on
the vacuum or let the powerfoot
tilt forward.

CAUTION:

To avoid personal injury
and to prevent the cleaner
from falling when cleaning
stairs, always place it at
the bottom of the stairs.

O

perations

Tip:

Before cleaning under

low furniture, check
area first for objects
that might harm the
unit or block the
vacuum hose.

CAUTION:

Before using your vacuum,
make sure that the dirt
container is in the locked
position and that all filters
(pre-motor and HEPA
post-motor) are in place. Do
not operate your vacuum
without these filters.

1.

2.

3.

ug603-2312_3990_806.indd 6

ug603-2312_3990_806.indd 6

8/18/06 4:49:23 PM

8/18/06 4:49:23 PM