Bissell 6393 Series - Manual (Page 5)

5
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
The only tool you’ll need to assemble your
vacuum cleaner is a Phillips screwdriver.
Attach handle to vacuum
1. Locate the handle and cord wrap. Remove
the screw packet taped to the cord wrap.
2. Stand the vacuum upright and from the
rear of the unit, slide the base of the handle
firmly into the grooves at the top of the
vacuum body.
3. IMPORTANT – before inserting the screws
into the handle, slide the cord wrap into the
handle.
4. Ensure that the handle and cord wrap are
firmly fit to the vacuum body. If there are
any gaps, continue to push firmly until the
handle and cord wrap are flush.
5. Insert 2 of the screws provided (3 total)
into the existing holes, attaching the cord
wrap and handle to the body of the vacuum.
Tighten securely with a screwdriver.
6. Attach the hose and cord clip by snapping
it into the handle of the unit. Secure it by
inserting the screw provided.
7. Attach the lower hose clip by snapping it
into place and twisting to the right.
Attach vacuum hose and tools
1. Line up the tabs on the base of the Twist ‘n
Snap hose with the corresponding notches
on the hose collar as shown.
2. Turn the Twist ‘n Snap hose to the left
to lock the hose into place.
3. Connect the curved hose wand to the hose.
Grasping the curved hose wand, slide the
end of the curved hose wand onto the hose
wand base. Snap the hose into the hose clip.
NOTE: The vacuum will not operate effectively
unless the curved hose wand is firmly attached.
A
ssembling your vacuum
CAUTION:
Do not plug in your
vacuum cleaner until
you are familiar with
all instructions and
operating procedures.
WARNING:
Plastic film can be dangerous.
To avoid danger of suffocation,
keep away from babies and
children.
2.
6.
3.
7.
Hose Clip
1.
Twist 'n
Snap Hose
ug603-2312_3990_806.indd 5 ug603-2312_3990_806.indd 5 8/18/06 4:49:22 PM 8/18/06 4:49:22 PM