Briggs & Stratton 592 - Manual (Page 6)

6
Figure 5
IMPORTANT: Perform the clutch rod adjustment before
operating the edger.
Clutch Rod Adjustment
Before operating the edger, check the adjustment of the
clutch rod as follows:
• Disconnect the spark plug wire and ground it as
instructed earlier in this section. Refer to Figure 2.
• With the blade clutch/depth control lever in the
disengaged position (the top notch in the depth
adjustment bracket), carefully pull the recoil starter
rope. The blade on the edger should not turn. If the
blade turns, remove the ferrule from the blade
clutch/depth control lever by first removing the
hairpin clip and flat washer.
• Rotate the ferrule clockwise one or two turns on the
clutch rod, then re-insert the ferrule into the lever
and recheck the adjustment.
• After adjusting, check to be certain the blade clutch/
depth control lever can be moved to the furthest
notch forward without bowing the clutch rod. If it
can’t, recheck the adjustment.
IMPORTANT: Be certain that the clutch rod is secured at
both ends with a flat washer and hairpin clip before
operating the edger.
WARNING: When operating the edger, stop
engine immediately and readjust the clutch
rod if the blade turns with the blade clutch/
depth control lever in the disengaged position.
SECTION 3: KNOW THE EDGER
Throttle Control
The throttle control lever is located on the engine. It can
be adjusted to regulate the engine speed only.
NOTE: Refer to the Briggs & Stratton Owner/Operator
Manual packed with your edger for a detailed
description of all engine-related controls and
components.
Choke Control
The choke control lever is located on the engine. It is
used to aid in starting a cold engine.
NOTE: Refer to the Briggs & Stratton Owner/Operator
Manual packed with your edger for a detailed
description of all engine-related controls and
components.
Blade Clutch / Depth Control Lever
The blade clutch/depth control lever is located on the
right side of the upper handle. It is used to engage and
disengage the edger blade. It is also used to control the
depth of the cut. The further forward the control lever is
moved, the deeper into the soil the edger blade will cut.
Pull Rope / Recoil Starter
The pull rope/recoil starter is used to start the engine.
NOTE: Refer to the Briggs & Stratton Owner/Operator
Manual packed with your edger for a detailed
description of all engine-related controls and
components.
Blade Angle Adjustment Lever
The blade angle adjustment lever is located on the
front, left portion of the edger, behind the edger blade. It
is used to vary the angle of the edger blade between
one of eight positions from trenching to trimming.
Curb Height Adjustment Lever
The curb height adjustment lever is found on the rear,
right portion of the edger. It aids in stabilizing the edger
operating along a curb.
IMPORTANT: Become familiar with all the controls
before operating the edger.
Clutch Rod
Pivot Arm
Flat Washer
Hairpin Clip