B&K AVP 2030 - Manual (Page 11)

Page 9
4. S-video inputs and outputs -
Connections for S-video components. Inputs labeled V1, V2, and
DVD/VLD. Outputs labeled V1, Z2/MON, and Z1/MON. The preamplifier
will not convert S-video to composite or composite to S-video. If you
wish to use S-video, you must use it through the entire system.
5. Digital inputs -
Inputs labeled V1, V2, TV-V3, TUNER, DVD/VLD, and CD used to
connect a digital audio signal from your source to the AVP preamplifier.
The incoming signal may be either a PCM or Dolby Digital signal, you
configure the input (in the setup menu) according to your system needs.
These inputs are coaxial only.
PLEASE NOTE:
The DIGITAL inputs on the AVP2030 will only accept an Industry Standard Consumer
Audio DIGITAL input signal.(See setup procedure in this manual)
When you connect a Dolby Digital source to an AVP with Dolby Digital, the signal
must be an Industry Standard Consumer Audio DIGITAL signal into the
AVP2030.
Laserdisc players normally have an Industry Standard Consumer Audio RF AC-3
signal. This type of AC-3 signal requires an AC-3 RF demodulator to be placed
between the player and the AVP2030. This converts the RF AC-3 signal, out of
the laserdisc, to an AC-3 DIGITAL signal. This signal can then be processed by
the AVP2030 digital inputs.
6. ZONE 1 PRE-OUTS -
Provides variable level audio output for sending to a power amplifier or
other audio component. They carry the same signal as the FRONT L and
FRONT R surround outputs.
7. ZONE 2 PRE-OUTS -
Provides variable level audio output for zone 2 to send to a power
amplifier or other audio component. These outputs are independent of
ZONE 1.
8. Analog audio inputs -
Line level inputs for connecting your audio components to the system
(TUNER, DVD/VLD, CD, and TV-V3). Must be used to send a signal to
zone 2. The FX/NC input is not available for connection as it is the
internal surround processor.