Blaupunkt FRANKFURT RCM 82 - Manual (Page 15)

31
Frankfurt RCM 82
DE
UT
S
C
H
EN
GLI
S
H
IT
A
L
IANO
POR
T
UG
UE
S
NE
DE
RL
AND
ESP
A
G
ÑO
L
SVEN
SK
A
F
RANÇAI
S
Acoustic Signal after the Actuati-
on of a Key (BEEP)
All functions which require for a keystroke
longer than two seconds (e.g. memorizing a
station) are confirmed by an acoustic signal
(BEEP).
For switching the BEEP tone on or off,
● press the DSC button 5 .
The display G a gives you “BEEP ON”
or “BEEP OFF”.
● Using the rocker switch << / >> I you
can select between ‘BEEP ON’ (acou-
stic signal on) and ‘BEEP OFF’ (acou-
stic signal off).
For memorizing your adjustment,
● press the DSC button 5 once again.
Choosing the Display Colour
With this set you can match the display colour
to the colour of your vehicle’s dashboard
lighting. You can choose between green and
orange.
For changing the display colour,
● press the DSC button 5 .
The display G a gives you “BEEP ON”
or “BEEP OFF”.
● Press the rocker switch << / >> I until
‘COLOUR’ lights up on the display
G a.
For changing the colour,
● press << / >> I ,
and the display colour will change.
For storing this adjustment,
● press the DSC button 5 once again.
Theft Protection by Code LED
As a preventive measure, you can let a light-
emitting diode (LED)
K blink in the car’s
interior when it is parked.
For modifying the setting,
● press the DSC button 5 .
The display G a gives you “BEEP ON”
or “BEEP OFF”.
● Press the rocker switch / J until
‘LED’ and a number light up on the dis-
play
G a.
● Via the rocker switch << / >> I , you
can adjust the following:
LED 0 -
Blinking is off.
LED 1 - LED only blinks if the car
radio is connected via the
ignition.
LED 2 - LED blinks, if the car radio is
switched off (using the ON/
OFF-button, KeyCard or
ignition).
Loudness
Since your in-car sound quality is influenced
by the type of the installation (amplifier), the
type and arrangement of the loudspeakers,
and the vehicle itself, you may individually
programme at which level you want the set to
start boosting the basses (loudness).
For changing this loudness level,
● press the DSC button 5 .
The display G a gives you “BEEP ON”
or “BEEP OFF”.
● Now press the rocker switch / J
until ‘LOUD’ and a number between 1
and 6 illuminate on the display
G a.
● With the rocker switch << / >> I you
can match the above mentioned loud-
ness level to your personal require-
ments.
For memorizing this adjustment,
● press the DSC button 5 once again.
Preset Naming
When you select a station, the display G a
will give you the frequency and for RDS
stations also the station name later on, e.g.
91.3
BBC3. You can replace the frequen-
cy indication of all preset stations without
RDS code by entering an 8-digit name.
Note the following: