Blaupunkt FRANKFURT RCM 82 - Manual (Page 11)

27
Frankfurt RCM 82
DE
UT
S
C
H
EN
GLI
S
H
IT
A
L
IANO
POR
T
UG
UE
S
NE
DE
RL
AND
ESP
A
G
ÑO
L
SVEN
SK
A
F
RANÇAI
S
Switching Traffic Messages (ARI) On
and Off
This function allows you to mute all the stati-
ons which do not broadcast traffic announce-
ments.
For switching ARI on and off
● Press the ARI button E .
If traffic radio is on, ‘ARI’ lights up on
the display
G n.
If you press the ARI button when listening to
a traffic message, the ARI priority is deactiva-
ted for this message. The radio switches over
to the operating mode which was activated
before the traffic message. But ARI priority
remains activated for the further traffic mes-
sages.
If your radio is tuned to a station without ARI
code, the acoustic alarm will be produced
after approx. 4 seconds.
● Tune to another station.
When pressing the ARI button while listening
to an MW or LW station, the unit automatical-
ly switches to the FM traffic station tuned in
last.
Acoustic Alarm
When leaving the coverage area of the tuned
in traffic station, your car radio automatically
sends out an acoustic alarm after approxima-
tely 30 seconds.
This alarm tone can also be heard when
pressing a preset button with no ARI station
allocated to it.
For switching off the acoustic alarm,
● search for a new station (see chapter
‘Tuning in a Station Automatically’). The
set will then start searching for the next
traffic station.
Automatic Start of the Station Seek
Operation
(cassette playback)
When leaving the coverage area of the tuned
in traffic station, your car radio will automati-
cally start searching for a new traffic station
while you are listening to your cassette.
During the seek operation, an alarm tone is
sent out.
Tape Section
Inserting a Tape
If you want to listen to a tape:
● Switch on the set.
● Insert the cassette halfway into the slot
with side 1 up and without applying
force; the cassette will be loaded auto-
matically.
The cassette side which was played last will
be reproduced.
From the display
G a you can see which
side is currently played. (TR1 = side 1)
Removing the Tape
To stop tape play:
● Press the buttons = simulta-
neously.
The cassette is ejected.
Fast Forwarding and Rewinding
the Tape (FF/FR)
Fast Forward Operation
● Press button FF > .
On the display G a e.g. the ‘<< >>’
symbols illuminates to indicate fast tape
operation. Once fast forwarding is finis-
hed, the reversed side will start to play
automatically.