Bay Technical Associates U140E116-02 - Manual (Page 13)

13
Device B (2,2)............2
Device C (2,3)............3
Device D (2,4)............4
Configure.........................C
Manual Mode.......................M
Exit..............................X
Unit Reset........................R
Logout............................T
Enter Request :
The device names in the menu correspond to the device names assigned to
the serial ports installed in the unit. To select a particular device simply enter
the number of the device then hit return. Refer to section 16.4 of the M-
Series DAC owners manual for configuration of device names.
The other items in the menu provide various functions described below:
Configure - Allows users enter into the configuration mode for any
installed modules or for the base unit. See Section 6 CONFIGURATION for
details to configure the unit.
.3 MANUAL MODE
Manual Mode allows users to manually select a module and/or port. The
“Manual Mode” selection for the V93A menu is used to make a module level
connection which is used for sending commands to the module. The “Manual
Mode” is used to make a connection to a module such as the Control Relay
Module, A-to-D Module, Event Counter Module, main board, etc. Use the
“Manual Mode” for module connections other than a Serial I/O module
unless you want to operate a Serial I/O module in the Command Mode of
operation. The “Manual Mode” selection should not be used for
configuration.