Bosch DINIONXF LTC 0495 - Manual (Page 21)

Dinion XF | Installation Manual
Bosch Security Systems | 2004-01 | V1.0
EN | 21
menu, the current area is displayed with the upper left corner flashing. The
flashing corner of the image can be moved with the Up, Down, Left, Right
arrow keys. Pressing the Select key moves the flashing cursor to the
opposite corner, which can now be moved. Pressing Select again freezes
the area and exits the area menu.
Video Motion Detection (VMD) submenu
Note
If VMD areas overlap, motion is only detected in the area with the lowest
sequence number.
Defaults submenu
Function Selection Description
VMD OFF, SIL, OSD When VMD is enabled and the camera can
generate SIL (silent) or OSD (monitor alarm
generates on-screen message) motion alarms.
AREA 1, 2, 3, 4,
Select submenu • It is possible to set 4 motion sensitive areas (per
MODE).
• Press SELECT to enter the area set-up menu.
ACTIVE ON, OFF Every area can be enabled individually by
selecting YES.
MOTION Press SELECT to
reset indicator Indicates the peak of measured motion in the
selected area
SENS Use the LEFT/RIGHT keys to set the SENSitivity
for motion to the desired level. Motion above this
level triggers alarm.
EXIT Return to Mode menu
Function Selection Description
MODE
DEFAULTS Select to restore the factory defaults. A
confirmation screen appears. Allow 5 seconds for
the camera to optimize the picture after a mode
reset.
EXIT Return to Mode menu
DinionXFD_Nv1_0.book Page 21 Friday, January 7, 2005 10:56 AM