Brother DECT BCL-D70 - Manual (Page 10)

Chapter 1
4
j
Enter the registered 4-digit PIN number
of the machine (base unit) (The factory
setting is “0000”.) by pressing the dial
pad on the control panel of the cordless
handset.
Press Menu/OK.
Note
• If you hear three short beeps, the cordless
handset did not register. Try to register the
cordless handset again.
• If you want to install another cordless
handset, repeat steps f through j.
• You can change the PIN number. (See
Modify PIN on page 22.)
• You may register GAP (Generic Access
Profile) compatible DECT™ handsets to
your machine (base unit). Follow steps a
through f, then refer to your handset
documentation to complete the
registration. Functions are limited to
making and receiving external calls. Some
handsets may not work with your
machine.
k
Press Stop/Exit on the control panel of
the machine (base unit).
Deregistering cordless
handsets
1
You can deregister your cordless handset.
If you are using more than one cordless
handset, deregistration will remove all
handsets registered with the machine (base
unit).
a
Press MENU on the touchscreen of the
machine (base unit).
b
Press a or b to display Initial
Setup
.
c
Press Initial Setup.
d
Press a or b to display Register
Handset
.
e
Press Register Handset.
f
Press Terminate.
Press Yes to confirm.
g
Press Stop/Exit.