Glen Dimplex Home Appliances Ltd PBI60R - Manual (Page 23)

Installation Instructions
Fitting into worktop
• Cut a hole in the work surface to the
required size. See table for relevant
dimensions.
A clearance of at least 50mm should be
maintained between the cutout and any
rear or side wall.
• The worktop must be of heat-resistant
material or covered with heat-resistant
material.
• Protecting the cut-out;
The types of chipboard used for work sur-
faces swell relatively quickly in contact with
humidity.
Apply a special varnish or adhesive to the
cut edge to protect it from steam or con-
densation which may form under the work
surface under the hob.
This hob can be installed conventionally (glass
above the work top) or recessed into the work
top for a flush fit.
Conventional Installation
Apply the self adhesive seal to the underside
edges of the hob glass. For best results, the
seal should be adhered along each side in turn,
as close to the edge as possible, and trimmed
at each corner, taking care to ensure a neat
join.
Place the hob in the aperture, checking the
hob glass is covering the work top along all
four sides. Set the front edge of the appliance
parallel with the front of the work top. Locate
and attach the securing clamps to the front
and rear underside of the hob, using the 2-off
pozidriv self-tapping screws provided. Tighten
the screws so that the hob is pulled down firm-
ly against the worktop, thus ensuring a good
seal.
Cutout required
WIDTH 550mm
DEPTH 480mm
Clearance required
SIDE WALL 53mm
REAR WALL 53mm
Important: Clamps may be
reversed to fit either 30mm or
40mm deep work top.
i
23
Screw
Clamp
Seal
Worktop