Bissell Cleanview Helix 22C1 - Manual (Page 9)

9
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
M
aintenance and care
Empty Dirt Container
the dirt container needs to be emptied when
the dirt reaches the “full” line on the side of the
container.
1. Unplug cleaner from electrical outlet.
2. Slide the Lock ‘n Seal lever to the "Unlock"
position.
3. Grasp dirt cup portion handle and pull
straight out to remove from vacuum.
4. Empty dirt into garbage container.
5. Put the dirt container back in the vacuum
and slide the lever to the "Lock" position.
note: the dirt container may be washed in
warm water with a mild detergent. Make
sure it is completely dry before replacing.
Cleaning the inner & outer circular filter
Use only genuine bISSEll style replacement
filters in your bISSEll Cleanview helix.
1. Unplug the cleaner from electrical outlet.
2. Remove the dirt container as described in
the previous section. Grasp the filter cup
located at the bottom of the dirt container,
lift up and out. DO NOT TRy TO PULL
CIRCULAR FOAM FILTER OUT OF THE FILTER
CUP WHILE IT IS STILL IN THE vACUUM.
3. Grasp the plastic tab on the top of the circular
foam filters. Twist to unlock and pull out.
4. Separate the outer foam and inner pleated circular
filters. Wash each individually by hand in warm
water. Mild detergent may be used if desired. Rinse
well, then air dry thoroughly before putting them
back together and replacing in filter cup.
5. The filter cup may be washed in warm water
with a mild detergent. Make sure it is completely
dry before reassembling with filters.
6. The upper tank and louvers may also be wiped
clean with a damp cloth. Reach underneath
the upper tank and turn the rim of the louvers
to unlock. Pull straight down to remove. Make
sure all parts are dry before replacing.
Full Line
Lock Position Unlock Position
2.
2.
3.
4.
3.