beautypg.com

Aintenance and care – Bissell Cleanview Helix 22C1 User Manual

Page 12

background image

12

w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1

M

aintenance and care

Cleaning a clog

low suction or poor pickup may be due to a clog

in the vacuum cleaner. If you notice a change

in the sound of the motor or a reduction in the

spinning action, check for clogs.
1.
Unplug cleaner from electrical outlet.

2. Empty dirt container.

3. Check upper tank for build up or clogs.

4. Check the suction inlet for a clog.

5. Grasp the quick reach handle and lift hose

wand to separate from the suction opening.

Check for a clog in the base, the wand or

the hose.

6. Remove the screw attaching the hose wand

base to the vacuum. Straighten the hose

wand base and unclog with long, narrow

object such as a broom stick.

7. If the clog persists, follow the instructions

for Checking the rotating floor brush on

page 11 and inspect the air passageway for

obstructions.

Replace light bulb

Use only bISSEll Replacement bulbs in your

bISSEll CleanView helix.
1.
Unplug cleaner from electrical outlet

2. Using a flat screwdriver, table knife or coin,

insert into the slot on the right of the lens

and gently push inner latch to the left as

shown to remove the lens.

3. Reposition lens by inserting the tab on left

side and then pushing the right side back

into place.

3.

4.

6.

2.

3.

This manual is related to the following products: