Behringer GX110 - Manual (Page 11)

11
ULTRAROC GX110
2. WIRING EXAMPLES
2.1 Standard setup consisting of guitar, footswitch and external effects device
To use your ULTRAROC for rehearsals or on stage, please wire up the unit as shown in fig. 2.1. Of course, you
can also use a wah-wah or other pedal effect instead of the external 19" effects unit, or simply work with the
internal effects without having to use the insert path at all. Connecting the headphones will mute the built-in
speaker.
When you wish to use a guitar tuner, please connect it to the INSERT SEND of your ULTRAROC. If there is no
further effects device connected, you can leave the INSERT RETURN as it is. However, to use an external
effects device, place the tuner before the effects in the signal chain, so that it works on unprocessed signals
only.
Fig. 2.1: Standard setup
2.2 Expanded setup with MIDI foot controller, playback source and mixing console
To use your ULTRAROC for advanced applications, please consider the following suggestions. Of course, the
expanded configuration suggested in fig. 2.2. builds on the standard setup described in chapter 2.1.
Use the MIDI foot controller to change presets and/or channels, set volume and wah, etc. The line out signal
can be fed into a P.A. or recording console, and the AUX input can be used to play back e.g. cassette recorder
signals through the GX110.
2. WIRING EXAMPLES