Bakers Pride VH1828E - Manual (Page 9)

Remove the front door and verify the proper orientation of the upper air return shield. c) The plenum
fingers are identical, so any finger can be mounted in any location.
d) Secure the (4) outer side panels to the main frame assembly using the ¼-turn fasteners that are
attached to these panels. Mount these side panels AFTER the conveyor has been properly
installed. (See above). Adjust the outer baffles UP / DOWN until they are in the correct position to
allow product to enter and exit with minimal vertical clearance. This will reduce the amount of heat
lost out the sides of the cook chamber.
'
REMOVABLE
PLENUM "FINGERS"
ASSEMBLY
ALL FOUR IDENTICAL
UPPER AIR
RETURN SHIELD
LOWER AIR
RETURN SHIELD
ASSEMBLY
INTERNAL FIXED
AIR PLENUM
ASSEMBLIES
END SLOTS TOWARDS
ADJUSTABLE BAFFLE
1/4-TURN FASTENERS
(2) TOP & (2) BOTTOM
( CAPTIVE TO COVER )
LOWER COVER
( LEFT SIDE )
HANGER PINS
( ATTACHED TO
UPPER COVER )
UPPER COVER
( RIGHT SIDE )
LOWER COVER
( RIGHT SIDE )
UPPER COVER
( LEFT SIDE )
ADJUSTABLE
BAFFLE
HINGED
FRONT DOOR
HINGED DOOR