Bakers Pride VH1828E - Manual (Page 12)

10. CLEANING
CAUTION: THE CONVEYOR OVEN CONTAINS ELECTRICAL COMPONENTS. TURN OFF THE OVEN
AND DISCONNECT THE POWER BEFORE CLEANING BEGINS.
DO NOT CLEAN THE CONVEYOR OVEN WITHAWATER JET.
Rinse with a MOIST, NOT SOAKING, cloth.
CAUTION: DO NOT USE OVEN CLEANERS, CAUSTIC SOLUTIONS OR MECHANICAL MEANS
BECAUSE THESE WILL DAMAGE THE ALUMINIZED SURFACES
NOTE: USE CARE IF CLEANING THE CONVEYOR BELT WHILE IT IS STILL MOUNTED IN
THE OVEN. EXCESSIVE FORCE MAY PRODUCE AN OVERLOAD CONDITION THAT
COULD DAMAGE THE GEARMOTOR AND CAUSE THE OVEN TO BE RENDERED UN-
USABLE.
Use only a damp cloth.
WEEKLY CLEANING:
Oven Exterior: CLEAN ONLY WHEN THE OVEN IS COLD.
Oven Interior: CLEAN ONLY WHEN THE OVEN IS COLD.
Conveyor BeltAssembly
Plenum “Fingers”
1. Remove crumb pans.
2. Remove plenum “finger” assemblies and disassemble for cleaning.
Standard construction of the exterior is
of stainless steel.
Deposits of baked-on splatter and grease, or discoloration may be removed by using any commercial
cleaner recommended for stainless steel. Always rub with the grains and apply very light pressure.
Standard construction of the interior
(cook chamber) is of aluminized steel, and requires care not to “over-clean” and scratch the surface.
. Use only the detergent solutions
and cleaners that meet national and/or local codes. Clean the walls of the cook chamber with a mild
soap and water solution.
To clean the interior of the conveyor oven, it is necessary to remove the front door, the (4) outer sides
panels, the conveyor belt assembly, and the (4) air plenum “fingers”. (See page 9.)
1. CONVEYOR BELT STILL MOUNTED IN OVEN:
Using a plastic abrasive pad, wipe the conveyor belt in a back-and-forth motion to remove
baked-on product. Wipe clean with a hot, damp cloth.
2. CONVEYOR BELT REMOVED FROM OVEN:
Using a plastic abrasive pad, wipe the conveyor belt in a back-and-forth motion to remove
baked-on product. Wipe clean with a hot, damp cloth.
NOTE: IT IS NOT NECESSARY TO REMOVE THE BELT FROM THE FRAME ASSEMBLY FOR
CLEANING.
3. Check the belt links for any sign of damage. If any links are bent, use a needle-nose pliers to
repair prior to re-installation into the unit.
The conveyor oven contains (4) plenum “fingers” that direct air onto the product surface while
cooking. This 3-piece assembly comes apart for cleaning, as shown below:
Remove conveyor belt assembly.
12