Bakers Pride VH1828E - Manual (Page 13)

The Outer Perforated panel is locked into place through a friction fit to the Main panel. This method
of fastening also captures the Inner panel, holding it in place. The Outer panel slides off the Main
panel, exposing the perforated Inner panel. The Inner panel is symmetrical in design, and may be
placed in either direction, as long as the outer flanges are pointing as shown in the figure
above.
The Inner and Outer panels are made of stainless steel, and therefore may be exposed to strong
cleaners to remove baked-on grease, etc. Overnight soaking in a hot cleaning solution will improve
the cleaning process.
The Main panel is made of aluminized steel like the main cook chamber, and thus requires the same
level of care to retain its integrity. Follow the same precautions as mentioned above for the main
cook chamber.
UPWARD
11. OPERATOR MAINTENANCE
WARNING DANGER DISCONNECT THE POWER SUPPLY BEFORE SERVICING OR CLEANING
THE OVEN. SERIOUS INJURY, INCLUDING DEATH, MAY OCCUR IF CONTACT IS MADE WITH
INCOMING POWER.
:
During normal operation of the oven, lubrication is not required.
To achieve maximum efficiency, keep the oven clean. How you maintain your oven will determine how long
it lasts.
If the oven fails to operate, perform the following inspections BEFORE calling an authorized service agent:
13
AIR PLENUM “FINGER ASSEMBLY”
Although symmetrical
in design, inner panel
must have flanges
facing up as shown
Inner Perforated
Screen
(Stainless Steel)
Outer Perforated
Panel
(Stainless Steel)
Main Panel
(Aluminized Steel)