Philips Sonicare Higienizador por rayos UV User Manual
Page 10
Using the appliance
Do not place the travel cap on the brush head
during sanitisation.
1
After brushing, rinse the brush head and shake
off excess water.
2
Place your finger in the door recess on the
right-hand side of the sanitiser and pull open
the door.
3
Put the brush heads into the sanitiser (see
chapter ‘Preparing for use’).
Note: Make sure the bristles of the brush head face the
light bulb.
4
Close the sanitiser door.
Note: The sanitiser does not work when the door is not
properly closed.
5
Put the mains plug in a wall socket.
6
Press the on/off button to start the UV clean
cycle.
Note: The sanitiser is in operation when the blue light
glows through the window on the front of the sanitiser
and the UV clean LED flashes slowly.
Note: The sanitiser needs to run for the full 10-minute
UV clean cycle to get optimal results.
Note: When the sanitising cycle is complete, the
UV clean LED turns solid green and the sanitiser
automatically switches off.
Note: You can stop the sanitiser during the sanitising
cycle by pressing the on/off button or by opening the
door.
EnglisH
10
4235.020.3683.1.indd 10
02-07-09 10:00