Bosch DSDA ISCSI DISK ARRAY SERIES DSA-S5B50 - Manual (Page 26)

24 en | Monitoring and Maintenance DSDA iSCSI Disk Array Series
V 1 | 2008.08 Installation Guide Bosch Security Systems
7.2 Maintenance
7.2.1 Disk Replacement DSA-S5B50
Follow these steps to replace a disk:
1. Remove the new disk drive from the antistatic bag.
2. Determine the disk drive to be replaced, see Section 7.5.1 DSA-S5B50, page 30.
3. Press the release latch of the drive. Swing the drive bay cover to the right until it is at a
right angle to the chassis.
4. Slide the entire assembly toward you in order to pull it out of the drive bay.
5. Press the release latch of the new replacement drive. Swing the drive bay cover to the
right until it is at a right angle to the chassis.
6. Slide in the drive carrier and close the drive bay cover.
The drive LED should be lit green now.
7.2.2 Disk Replacement DSA-N2B20 / DSA-N2B50
Follow these steps to replace a disk:
1. Determine the disk drive to be replaced, see Section 7.5.2 DSA-N2B20 / DSA-N2B50,
page 30.
2. Grasp and pinch the latch.