Philips Matchline Flat TV - Manual (Page 94)

14
MODE
VCR
DVD
· ¢ К Ж
∫
У
ı
Ω ∆
.
Z
¤
Connecting peripheral equipment
Depending on the version the TV is equipped with one or two EXT1 and EXT2 sockets.
A special adaptor is supplied to connect to EXT1 and can route the leads to the back.
The EXT1 socket has audio, CVBS/RGB inputs and audio, CVBS outputs.
The EXT2 socket (if available) has audio, CVBS/S-VHS inputs and audio, CVBS outputs.
Video recorder (or DVD recorder)
Carry out the connections shown opposite, using a good
quality euroconnector cable. If your video recorder has the
Easylink function, use the EXT2 socket.
If your video recorder does not have a euroconnector socket, the
only connection possible is via the aerial cable.You will therefore
need to tune in your video recorder's test signal and assign it
programme number 0 (refer to manual store, p. 6).
To reproduce the video recorder picture, press
0
.
Video recorder with decoder
Connect the decoder to the second euroconnector socket of
the video recorder.You will then be able to record scrambled
transmissions.
Video recorder
Satellite receiver, decoder, DVD, games, etc.
For TV sets with 2 SCART connectors, preferably connect the
equipment delivering RGB signals (digital decoders, DVD
players, games consoles, etc.) to EXT1 and the equipment
delivering S-VHS signals (S-VHS and Hi-8 VCRs) to EXT2.
To select connected equipment
Press the
n
key to select EXT1 and on the versions with 2 scarts,
EXT2 , S-VHS2 (S-VHS signals from the EXT2 socket) and EXT3 .
Most equipment (decoder, video recorder) carries out the switching itself.
Other equipment
FM ANT :
VCR
Audio
out
L R
Sub
woofer
out
*
L
R
Audio in
(PC)
DC in PC input
FM ANT
EXT 1
:
EXT 2 *
L R
Audio
out
Sub
woofer
out
*