Bosch Nexxt DLX - Manual (Page 22)

22
During WashĆ
ing
i Due to the highly engineered
suspension of this appliance,
it may experience a shudder
or shake when progressing
from lower to higher spin
speeds. This behavior is
normal due to shifting of the
drum system and should not
cause concern.
Changing a program
q Turn the program selector to
Off.
q Turn the program selector to a
newly selected program.
The Start/Pause indicator light
flashes.
q If required, change the settings;
see from Page 19.
q Press the Start/Pause button.
The program starts.
The indicator light is lit.
Add a garment /
Interrupting the
program
You can put laundry in the drum afĆ
ter washing begins, take laundry
out of the drum early or interrupt the
program at any time.
i It is not recommended to add
laundry after the washing phase
is complete.
i You can add or reduce laundry
as long as the Start/Pause
indicator light flashes (red).
q Press the Start/Pause button.
The Start/Pause indicator light
flashes.
q Open the door.
q Place/remove the laundry.
q Close the door.
q Press the Start/Pause button.
The program continues.
The indicator light is lit (red).
i When the Start/Pause
indicator light is lit (red), the
program can be interrupted,
however the door cannot be
opened for safety reasons
(water level, temperature or
speed too high).
i If the spin speed is too high, the
Start/Pause indicator light is lit
(red). Laundry can be added in
Pause" mode when the drum
is at a standstill.
Canceling an active
program
If you would like to terminate a
program and remove the laundry:
i If a program is interrupted at a
high temperature, leave the
laundry to cool down until the
glass is cool to touch.
q Turn the program selector to
Off.
q Turn the program selector to
Drain or Spin.
i For Spin, select the desired
spin speed (but not no final
spin).
q Press the Start/Pause button.
q Wait until this program ends.
q Open the door.
q Unload the laundry.
i If a program is interrupted at a
high temperature, the door may
remain locked until the
appliance has cooled down.
i If the program is terminated by
switching off the appliance, the
door may remain locked.
After Washing
The Start/Pause indicator light
goes out.
0:00 appears in the display.
q Open the door.
q Turn the program selector to
Off.
q Close the taps.
q Remove the laundry.
If No final spin" preselected
The Start/Pause indicator light
flashes.
q Turn the program selector to
Drain. The Start/Pause
indicator light flashes.
q Press the Start/Pause button.
The indicator light is lit.
q When this program has ended,
open the door.
q Turn the program selector to
Off.
q Close the taps.
q Remove the laundry.
q Leave the loading door ajar to
allow the inside of the washing
machine to dry.