Bosch Nexxt DLX - Manual (Page 11)

11
Water drainage
CAUTION
Do not bend or pull the water
drainage hose.
Height difference between the
installation location of the washing
machine and the drainage point:
Maximum 8 feet / 244 cm.
Connecting the water
drainage hose
q Attach the drain hose to the
end of the drain connection.
q Secure the connection point
with the clamp and tighten.
Standpipe Installation
q Use the elbow. Attach the
elbow to the end of the hose
and insert end of hose into
standpipe.
q Use a strap or cable tie to hold
hose in place.
In-Wall Installation
q Use the elbow. Attach the
elbow to the end of the hose
and insert end of hose into wall
drain.
q Use a strap or cable tie to hold
hose in place.
Drainage into a siphon
q Secure the connection point
with a hose clip(not included in
factory-supplied equipment).
Drainage into a sink
CAUTION
Ensure that the plug is not in the
drain hole.
q Attach water drain hose
securely to sink.
q Use a strap or cable tie to hold
hose in place.
q When the water is being
drained, check that the water
flow out of the sink is adequate.
Transport, such as
when moving out
Before transporting the washing
machine:
- Turn off the water.
- Disconnect the washing
machine from the power outlet.
- Dismantle the supply and
drainage hoses.
- Install the transport bolts.
i Having transported the
appliance and ensured proper
installation and connection,
allow the Drain program to run
through before starting the first
wash program.
Preparing and inserting the
transport bolts
q Remove the covers.
q Prepare the transport bolts:
Loosen the screw in the sleeve
until the end of the screw is
level with the end of the sleeve.
q Insert and tighten all transport
bolts. Make sure that the tab on
the transportation bolt is
inserted in the slot on the
washing machine back panel.